Vise Recomendation

[swamprattler]

I have a Double swivel Vertical Slide for my Myford Super 7 lathe. Can someone please tell me which vise I should buy for this, so that i can do some milling operations.

Thankyou
Gil

 

[DICKEYBIRD]

I bought a 2" "screwless" vise from Enco and mounted it on my compound slide which was mounted on a 4" cast iron angle plate to perform milling ops. Here's a pic:

It served me well until I finally got an X-3 mill last year. You have to take small cuts and keep those gibs tight to reduce the chatter. Here's a link to the vice, top left of the page.
http://www.use-enco.com/CGI/INPDFF?PMPAGE=408&PARTPG=INLMK32