Peter Twissell

The rods used to fixture the fitting were then used to keep the wall from compressing when it was put in the vise to profile the flange...

Hi k2, I regularly climb mill on my (manual) machine. I just nip the gib clamps enough to prevent the cutting load from snatching the...

Full size guidelines, equally applicable to models, are 150C max for aluminium heads, 180C max for iron. As Brian says, small engines...

This ultimately led me to what you see here. I made a new bushing that has 2 captive O-rings. The lower one is a bit wider & thicker; it...

K2, While all you have written about grubscrews and cams is correct, have you calculated the magnitude of valve train loads in a model...

My phone contains many photos of blackboards, whiteboards, other people's notes etc.

Not to worry. I started a thread on another forum 13 years ago and I haven't posted there for over a year. I still haven't finished the...

This little item took a long time to make and install. It's the mounting bracket for the exhaust rocker arm. Thanks for looking Ray