lathe nut

this is one I built for small cutting things, the 10" Carolina does the big work, it is a Harbor Freight Saw, make the bracket to make...

SmithDoor, did check that out no look but do have it on watch notification. k2steve, back when I bought this one that had up to 20" if I...

I need some help if someone can, this Harbor Freight lathe, 1440 was wondering if anyone knew who made it made it for them, I called...

awake, I tried them it is most defiantly a 4MM, maybe at some point in its life it decided it did not want to be like his friends, I did...

Guys, I did give a response and clicked on Reply and it went into outer space, do the make a die that would fit that thread on the...

Guys, I did give a response and clicked on Reply and it went into outer space, do the make a die that would fit that thread on the...

cc

Well guess I misunderstood with the Language you used, then I ow you an apology, I have attached some pictures to show the 4MM thread...

Richard Hed, I only ask for help, I apologize for getting you up set and causing you to curse me and to be angry, guess I don't know...

I have some Delrin, going to try and cut some threads before I do the internal one but if worse comes to worse, I will take the dividing...

I did get a metric thread gauge, it is showing 4MM, I measure across the threads, possible 39 or 4, not been able to find much out about...

Thanks so much guys, with all that information sure hope to figure it out, someone told me that it is probably a 4 or 5MM thread, not...

Hey all, a fellow stopped by the house which is a part time scrap dealer like me, he said that had some machinist stuff wanted to know...

Hello all, I am in the progress of restoring a Carroll, 6" dividing head, it has all the plates and all the pieces, it has the 1 3/4 X 8...