ShopShoe

I agree with Steve Hucks. Since there are four in each size it might be they were set up to level or space some kind of jig for a...

Steamchick, I may be missing something in your description of your headroom and drawbar issue: My apologies if I am. If you used a...

Building on what ajoeiam said above: I've owned several compressors over my life and have gone full circle on how I take care of them...

Beautiful. It is nice that you can get noise and smoke when you "fire" it. Congratulations on making it without published plans. You...

hi folks: As a frequent lurker and learning much from the HMEM community I wanted to share this project. Its not exactly a working...

ajoeiam, Panel Cutters are so simple you don't really need a drawing to make one. You can find more information on this Norm Abrams...

awake, Congratulations on a heck of a deal on the table saw and double congrats on your remilling of the slots. I think Grizzly can...

I agree with what Richard Carlstedt says above. I also have a vise purchased from Enco when they were in business that I disassembled...

I wrote a building report that got published in the German magazine " Maschinen im Modellbau"

I finally got tired of cranking the the Z axis up and down. So I decided to have a go at adding a power feed. There are plenty of good...

Ok lets say your tail stock does pass as pointing in the correct direction and within the allowable limits, or at worst, even straight...

That is beautiful. It is attractive just sitting there, but it runs very well, especially at low speed (which is what I like). The blue...

That's really nice. The engine with it's visible working parts is quite attractive and looks quite industrial. I can add my name to the...

If you haven't seen this link before, you can probably find information at: http://vintagemachinery.org -- Usually a "plug it in and...

I call this project finished. 1" piston 2" stroke 8" flywheel water cooled 181 degrees highest recorded temp at cylinder head 156...