Home Model Engine Machinist Forum

Help Support Home Model Engine Machinist Forum:

T
Reaction score
181

Latest activity Postings Media About

    • T
      timo_gross replied to the thread Elmers Engine 2x#33.
      Yes, getting used to my clumsiness, I will end up with 60 useable parts and several (hopefully less than 49) scrapped ones. .... :)...
      • K1600_DSC00109.JPG
    • T
      timo_gross replied to the thread Elmers Engine 2x#33.
      parts for the base, the one on the right is scrap. Flipped the part wrong from right to left, so all the holes from the underside ended...
      • K1600_DSC00108.JPG
    • T
      timo_gross reacted to anday1's post in the thread small camshaft with Like Like.
      Cam shaft made with help from jason and appreciate all your help and comments
    • T
      Maybe the link helps to understand what you have got here on the picture. I am sure it will also sharpen wood working tools...
    • T
      timo_gross replied to the thread Elmers Engine 2x#33.
      Finally first "non printed" "now virtual" part.
      • flywheel (2).JPG
      • flywheel.jpg
    • T
      timo_gross reacted to Jasonb's post in the thread Elmers Engine 2x#33 with Like Like.
      Started with some 40 x 60 steel which I roughed down on the manual mill to 53 x 34 x 131 long and them machined from that, all sides...
    • T
      timo_gross replied to the thread Elmers Engine 2x#33.
      I will stick to the internal version for now. The plan B is to move the valves to the top. So the "loco" thing is just the basic...
    • T
      timo_gross replied to the thread Elmers Engine 2x#33.
      Where I am reading that thread probably already puts me half in prison. :cool: I stick to models.
    • T
      timo_gross replied to the thread Elmers Engine 2x#33.
      A lot of the advice is valuable for near future. Maybe I have to read through it once over. The "free floating" eccentric without the...
      • locomotive eccentric_.jpg
    • T
      timo_gross replied to the thread Elmers Engine 2x#33.
      Yes that makes sense. Have to see if it is possible, because the cover will be is quite small. 22x15 mm or (0.9x0.6"), not much material...
      • virtual_fly_wheel.jpg
    • T
      timo_gross reacted to Jasonb's post in the thread Elmers Engine 2x#33 with Like Like.
      I don't think you will have a problem getting it assembled, it is just a bit more fiddly with them facing inwards. You could probably...
    • T
      timo_gross replied to the thread Elmers Engine 2x#33.
      Yes, apparently they are made of all sorts of materials. Organic, Brass, Aluminium, some even may have some titanium parts inside...
    • T
      timo_gross reacted to awake's post in the thread Elmers Engine 2x#33 with Like Like.
      Just to round out the confusion ... I thought all of the eccentrics were members of this forum! :)
    • T
      timo_gross replied to the thread Elmers Engine 2x#33.
      Haha I thought spanner and wrench are basically same thing? I am not native writer, so my English can be very off at any time. :) Yes...
    • T
      timo_gross reacted to Jasonb's post in the thread Elmers Engine 2x#33 with Like Like.
      Makes for a simple crankshaft where the single crank webs just fit either end of the shaft, if you have them facing out you need two...
  • Loading…
  • Loading…
  • Loading…
Top