Latest activity
Help Support Home Model Engine Machinist Forum:
-
Watch these three videos by Lars which should get you started. Couple of things have updated since he did them but basically the same. -
clockworkcheval replied to the thread Question regarding hardening of 01 steel.I'm wondering whether you should heat up the whole end where the lobe sits and then quench in oil with the axis perpendicular to the oil... -
OBeautiful work, Peter I've linked the YouTube video you referenced.
-
JJohan Theo Maritz replied to the thread Elmer Verburg's #6 Slider.That is now a challenge, making it a 2 cylinder, to me this is small and very fiddly to work with, keep us posted.
-
-
AAfter some sketchy band sawing, the 2"x4"x10" starting workpieces for the manifolds wound up being the last of the large chunks of my 25...
-
Steamchick reacted to Rdean33422's post in the thread Henry Ford's Kitchen Sink Engine (my version) with
Like.
I made a tapered bushing for the flywheel. This flywheel was the one I was going to use on the Benz engine but it was too small there... -
Steamchick replied to the thread Henry Ford's Kitchen Sink Engine (my version).A pretty looking flywheel. I like the double curved spokes. Was it cast as such? - Or as a hand-wheel and has had the rim reduced to a...
-
GAfter some sketchy band sawing, the 2"x4"x10" starting workpieces for the manifolds wound up being the last of the large chunks of my 25...
-
a41capt reacted to Rdean33422's post in the thread Henry Ford's Kitchen Sink Engine (my version) with Like.
I made a tapered bushing for the flywheel. This flywheel was the one I was going to use on the Benz engine but it was too small there... -
KKellisRJ reacted to clockworkcheval's post in the thread Mitutoyo 1-2inch digital mic failure with Like.
I love all mechanical measurement tools.
-
GreenTwin reacted to Rdean33422's post in the thread Henry Ford's Kitchen Sink Engine (my version) with Like.
I made a tapered bushing for the flywheel. This flywheel was the one I was going to use on the Benz engine but it was too small there... -
GreenTwin reacted to a41capt's post in the thread Henry Ford's Kitchen Sink Engine (my version) with Like.
I felt a lot like Henry while trying to get mine running. This was my first IC engine, only having built a couple LTD Stirling engines...
-
GreenTwin reacted to a41capt's post in the thread Henry Ford's Kitchen Sink Engine (my version) with Like.
This is a nice looking project as a scaled down version. I built a full sized Ford first engine complete with cast iron rings and...
-
There was a time when I was learning 3D modeling, where I would get frustrated, and just decide to go back to using 2D modeling. I also... -
Well my initial call to fusion was a total bust. I explained I have enough experience in solid modeling to probably pick up fusion...
