chipstractor
Well-Known Member
- Joined
- Aug 18, 2008
- Messages
- 54
- Reaction score
- 5
Pictured are the two sleeves along with one of the block/heads. The block/head was machined 3x4x5 6061 stock, the head (top center) was parted off.
The sleeves are cast iron, stock. Currently I have them honed at a local shop for 12 bucks a piece.
Still have a lot of figuring to go, but I hope to have it looking like a combination of these two..
Twin like this
But sized/styled like this...
I hope to be able to post progrss soon.