GreenTwin

I made a tapered bushing for the flywheel. This flywheel was the one I was going to use on the Benz engine but it was too small there...

I felt a lot like Henry while trying to get mine running. This was my first IC engine, only having built a couple LTD Stirling engines...

This is a nice looking project as a scaled down version. I built a full sized Ford first engine complete with cast iron rings and...

I have tried a few 3D modeling programs, and watched videos of others, and they all seem to be about the same. Create or pick a plane...

Webster Drawings Hope these help Mike1

There was a time when I was learning 3D modeling, where I would get frustrated, and just decide to go back to using 2D modeling. I also...

There are several more likely subjects, this 1820s print for example, also has the coffered base coffered base.

That's what I said yes. I'll see if I can find where I posted the details. Found a couple of photos....these are OTP coils (on the...

I needed a buzz coil for a little Stove Pipe Domestic I just got from a friend (the Herder engine casting set, with about 4" flywheels)...

Attached are the drawing notes to go with the Kerzel engine plans Rdean33422 posted.

This may be what you are looking for.

I watched the art-iron cupola folks pour iron for several years, and finally the lure was too great, and I said "I have got to do that"...

I was on two backyard casting forums over a period of about 9 years, and I read everything that was posted (tons of stuff). We debated...

The number of cats we have at any give time depends on which ones wander in. We have permanent indoor cats, and then if we find a stray...

Metal shrinks as it cools from a molten state, and so your patterns have to be made slightly larger than the finished part size. There...