Help Support Home Model Engine Machinist Forum:
R
Rdean33422
- Messages
- 129
- Reaction score
- 231
Latest activity Postings About
-
-
RRdean33422 reacted to raveney's post in the thread 1916 65 HP Case Traction Engine 1/16 Scale with
Like.
Made the "Horn plates" out of 20 gauge steel instead of the 22 gauge so I could add fake stay rivets like the real boiler. Should add... -
RSo, what did I do today?--I made and installed the gasket which goes between the manifold and the cylinder---the gasket that goes...
-
RRunning. Seems it likes about 240 RPM with that amount of heat. I haven't tried messing with displacer timing to see if small changes...
-
RThere was also an after-market Cobra oil pan available for some of these engines, but in my opinion it was a little gaudy, and so I...
-
RRdean33422 replied to the thread My Flat Head Hit Miss Engine.Thank you Sid I try to make each project a little bit better than the last. Ray
-
RSo today I managed to get a bit more done to the boring head I'm making, yes I know you can buy them for far less than the man hours I'm...
-
RRdean33422 replied to the thread My Flat Head Hit Miss Engine.Sparky I used an o-ring on the piston. Maybe next model I will try to make some piston rings for it. Ray
-
RRdean33422 reacted to Carbuilder's post in the thread Little Demon V8 - helpful hints (hopefully) with Like.
There is a little more info on it in post #57. It is a piece of blade from one of these: I just snapped off one of the sections and...
-
RRdean33422 replied to the thread My Flat Head Hit Miss Engine.Thank you Brian Ray
-
Rhello exhaust rocker arm, dummy oiler, muffler
-
RToday I finished machining the governor and installed it. This is not a terribly challenging part of the build, but it is right on the...
-
RRdean33422 reacted to Carbuilder's post in the thread Little Demon V8 - helpful hints (hopefully) with Like.
Cylinder liners done. I started making them as I described, cutting the material to length to get 2 liners. Drilled them with a 14.5mm...
-
RRdean33422 replied to the thread My Flat Head Hit Miss Engine.I have never made plans or drawings for my engines except for the ones I showed earlier just to get a close idea for fit. I am ready to...
-
RRdean33422 replied to the thread My Flat Head Hit Miss Engine.Thanks Minh John I have never seen a hit miss on a wood saw but I can imagine the sound as it changes from hit miss to continual...
-
RRdean33422 replied to the thread My Flat Head Hit Miss Engine.Yes it runs Issues that had to be fixed. I had to move the gas tank up 1" as the fuel level would drop in the fuel line and there...
-
-
-
Loading…
-
Loading…
