stevehuckss396

That's some beautiful work. It's amazing what you do with the step off chart.

They look like screw jack's. Looks like the previous owner made them for a specific job. Usually the top is flat.

George! I think that was vendor space. Exibitor spaces are the same first come, first serve as usual.

HI!

If you are trying to make big power you might want to also see what existing cams measure. Lift, Duration, lobe seperation, all have an...

That spreadsheet just calculates the height you cut for a given degree to form the lobes. You have to know the Base circle, nose radius...

Cant blame covid. There have been years where the show could have gone on.

I have it on good athority. Even people who sit on the board have very little hope that there will be another show.

Sorry art. I posted 2 weeks before asking who is going. The car and airplane part of the show were well exhibited. Just the models were...

NAMES is over. There won't be another one.

The show thus year was a bit of a let down. Only seemed to be about 1/3rd of the exhibitors. Was the same day as the black hills show...

If your system is working fine, why change it. My computer was 27 years when I started having issues. I started using the computer as a...

Typical setup is Pin1 not used Pin2-9 outputs (step & dir for 4 motors) Pin10-13 inputs (limit switch, button, etc) Pin14 output Pin15...

If you are just starting out go straight to Mach4. Developement on Mach3 has ended. Mach4 is just as capable and contines to be refined...

Mach4? I would say yes. If its like Mach3 everything works as it should but only 500 lines of code would be exacuted and it stops. With...