crankshafter
Well-Known Member
- Joined
- Jul 17, 2007
- Messages
- 367
- Reaction score
- 24
Hello all.
Well I have to move the Upshur twin project over here where it belongs ," Work in Progress".
Finished coolingfins for the 2'nd cyl. and and have them shrink-fit on the cyl. And pre-lapped both cylinders ;D just have to finish them with toothpast to get the bores real shiny. Think I will use Viton o-rings on the pistons like I did on my Webster.Have had the Webster running for some hours now, and it is a easy "starter" :big:
Ok here are some pix. from to night's progress.
Lapping.
fitting coolingfins on cyl.
And here both cyl.test fit on the crankcase.
More to come
Regards CS.
Well I have to move the Upshur twin project over here where it belongs ," Work in Progress".
Finished coolingfins for the 2'nd cyl. and and have them shrink-fit on the cyl. And pre-lapped both cylinders ;D just have to finish them with toothpast to get the bores real shiny. Think I will use Viton o-rings on the pistons like I did on my Webster.Have had the Webster running for some hours now, and it is a easy "starter" :big:
Ok here are some pix. from to night's progress.
Lapping.
fitting coolingfins on cyl.
And here both cyl.test fit on the crankcase.
More to come
Regards CS.