basement_guy
Junior Member
- Joined
- Sep 29, 2012
- Messages
- 51
- Reaction score
- 14
I have already made some parts.
The base, flywheel and some small parts are ready.
Now I'm working on the cilinder.
There is a story for the "special" design flywheel
I pilotdrilled 6 holes, then I drilled some bigger. I made the first hole 8mm, following my calculations (inch to metric). When I wanted to drill the second hole next to the first one I realised it was not possible. The holes would interfere. For simetrical reasons I drilled the opposite hole to 8mm. but left the other 4 with a smaller diameter.
The base, flywheel and some small parts are ready.
Now I'm working on the cilinder.
There is a story for the "special" design flywheel
I pilotdrilled 6 holes, then I drilled some bigger. I made the first hole 8mm, following my calculations (inch to metric). When I wanted to drill the second hole next to the first one I realised it was not possible. The holes would interfere. For simetrical reasons I drilled the opposite hole to 8mm. but left the other 4 with a smaller diameter.