Thanks to all for the support, it really helps keep the motivation going.
I just tidied up a few bits today as I wanted to get on with my air cooled amanco model. While having a well deserved coffee and a nice piece of cake, I was looking at the pump and think that it is such a nice model that I may mount it on its own and try and find a small geared motor to put in the base. This would allow me to drive it on its own or with an engine if I desired.
What does anyone think about running it on its own??
Well it`s been a long time since I posted on the progress of the pump. It has not been the best of weather for finishing and painting but I have finally got it done. The base was made from 3mm plate with a teak top on it. The tank is a piece of pipe with ice lolly sticks glued to it to make it more like a barrel. The transfers were made by myself following the markings on the drawing for guidance. The pump and the base are painted in satin black. I added some small oilers with caps to the main bearings, these were not on the original but I thought it was the best way to get lube into the bearings and look the part.
I have enjoyed the process from taking a drawing to get it to a finished working article and it look as the original. I have had it belted up to my R&V model and it runs a treat Would I do it again? Yes, in fact I am going to measure up a full size Grover engine to try and reproduce it, the engine is gas with hot tube ignition and flyball governer to control the speed, everything you could wish for in an engine really !!!
Here are the photos of the completed pump, I hope you enjoy them. Will take a video when time allows.
Cheers,
MartinH
P.S. I will try and get the drawings finished asap.
Magnificent workmanship Martin, and wonderful attention to detail even down to brass grease nipples and a lovely black finish and badging as per the original.
Hi Martin,
That's one classy piece of machinery you have built. Your build thread was great and the finishing touches add to it's beauty. Excellent!!!
gbritnell
Thanks for all the comments, they really are appreciated. As I said in an earlier post CAD is not my favourite thing to work with, I seem to spend hours on one drawing that takes two minutes on a scrap of paper. I have most of it drawn up now, just the difficult shaped parts to figure out how to do.
Thanks for that info Pat, I have persisted with the CAD drawings after following your intro post a few months back. Was getting on well untill I hit the fancy bits!!!!!
Martin, Wow!!!....somehow i missed the beginning of this thread and then "flash" it seemed to be done. What a beautiful job in every aspect from the fabrication to the finishing and even the great transfers (lettering). I have just read through the whole thread. The whole thing is both unique and inspiring.