Home Model Engine Machinist Forum

Help Support Home Model Engine Machinist Forum:

W
Reaction score
105

Latest activity Postings About

    • W
      Weldsol reacted to mayhugh1's post in the thread 1/3 Scale Ford 289 Hi-Po with Like Like.
      After weeks of tedious preparation, the last three surfaces of the workpieces could be machined so I'd finally have something that...
    • W
      More bits done, yet even more swarf but then that is to be expected Got the crank sorted out it is a made up one and according to the...
      • Crankshaft parts.jpg
      • Finished crankshaft.jpg
      • Flywheel blank.jpg
      • Final truing up of flywheels.jpg
      • Flywheel after milling.jpg
    • W
      One thing you could check (if the carb is as a full size one ) SU's used thin oil as a damper in the top of the piston guide and if the...
    • W
      Weldsol reacted to Ghosty's post in the thread Mills 1.3 with Like Like.
      Hi All, P.S. Remounted crankcase to show final cutting of case. tool post compound set at 7deg for cutting. Access for grub screw is...
    • W
      Weldsol reacted to Ghosty's post in the thread Mills 1.3 with Like Like.
      Last couple
    • W
      Weldsol reacted to Ghosty's post in the thread Mills 1.3 with Like Like.
      Hi All, Got on with the outside of the crankcase/body. Started with the base/engine mount lugs, then the top sides, then cut the sides...
    • W
      Weldsol reacted to Ghosty's post in the thread Mills 1.3 with Like Like.
      Hi All, Started the machining of the crankcase, setup, trued and centered, machined crankshaft pocket and bore, and threaded for...
  • Loading…
  • Loading…
Top