My 'Starter Projects' from a long time ago

Home Model Engine Machinist Forum

Help Support Home Model Engine Machinist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Tomlinson

Well-Known Member
Joined
Feb 10, 2017
Messages
61
Reaction score
125
Location
Cranswick, E. Yorks
Like a lot of budding model engineers, I started with a Stuart Turner kit.

These were convenient.

Without a well provisioned workshop, they contained most of what was needed to complete the job.

S T double 10.JPG


S T Compound Launch.JPG


S T No 9.JPG
 
Very nice looking jobs indeed. Were the kits as expensive back then as they are now?
 
I can't remember what I paid for the kits back then but I think they were relatively cheaper. All castings seemed to be cheaper and more available.
 
Tomlinson,
V nice models but a question. On the horizontal engine is the governor active or ornamental? I can see an eccentric strap on the flywheel side but can't fathom if or how that links to the governor Can you elaborate, please.
Bob D
 
The governor is a working one, the drive pulley is on the crankshaft behind the valve eccentric and the driven pulley is at the base of the governor. There is no belt fitted in this photo. The far eccentric is for the water pump.
 

Latest posts

Back
Top