Finished Vise Project

Home Model Engine Machinist Forum

Help Support Home Model Engine Machinist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Jack

Well-Known Member
Joined
Jul 9, 2007
Messages
177
Reaction score
12
Hello Everyone

After seeing several post about a little vise, I thought that I might like to try one. Well I have been working on it for about a month while moving my new surface grinder and shaper into the basement shop. Here a couple of before and after pictures, I am very happy with the way it turned out and with the help of a few new friends it will now take its place on the model shelf of fame.

IMG_0176.jpg


ViseCompleted.jpg


FinishedVise.jpg


Thanks for looking:

Jack

 
Hi Jack,
I like the idea of mounting it on a square block. It should let you mount it on the machine with a square and save all that mucking about with the DTI. Well done :bow:

Jim
 
Jack - Nice looking little vise.... You did a beautiful job and should be proud of it.

Harold
 
HI all where are you getting the castings from for the vice regards bob
 
Hello folks

Been away for a while, I like this little vise too, very nice job :bow:
 
Jack

Nice job on the vise!



Thanks for sharing.
Dave
 

Latest posts

Back
Top