azroyhelmy
Member
- Joined
- Mar 28, 2011
- Messages
- 16
- Reaction score
- 0
Hi guys,
I quite new to the CAM. I'm using 3 axis Fanuc controller mill and 9.1 version of mastercam.
My question is, how can i control my cutter wear? e.g : I'm ramping a 1" hole to 0.5" depth. my finishing cutter should make the last cut of 1" diameter at 0.5" depth. after checking the hole, the diameter is small of 0.0039".
So how can i used the 'wear' in tool offset controller? i tried before but the controller triggered an alarm not to do that. should i change the program? If so can anybody direct me to which i should select my 'offset' in Mastercam ?
Tq
I quite new to the CAM. I'm using 3 axis Fanuc controller mill and 9.1 version of mastercam.
My question is, how can i control my cutter wear? e.g : I'm ramping a 1" hole to 0.5" depth. my finishing cutter should make the last cut of 1" diameter at 0.5" depth. after checking the hole, the diameter is small of 0.0039".
So how can i used the 'wear' in tool offset controller? i tried before but the controller triggered an alarm not to do that. should i change the program? If so can anybody direct me to which i should select my 'offset' in Mastercam ?
Tq