Mike,
That would work also. But moving the laser on the face of the mill is in the same plane too. So if the mark is lower/higher I just tilt the laser to hit the target. Either way, we'll both be good!
Tony
Just re-read your post on spot size.....I mark to one side or the other of the spot (left or right) your choice
That would work also. But moving the laser on the face of the mill is in the same plane too. So if the mark is lower/higher I just tilt the laser to hit the target. Either way, we'll both be good!
Tony
Just re-read your post on spot size.....I mark to one side or the other of the spot (left or right) your choice