Hello Folks
Well I finally got started on my next project.
It will be an engine type looking a bit like the ones used in paddle steamers, the type where the paddle wheel was behind the hull.
A CAD of the hole project :
The project so far :
I also would like to show a close up on the bolts that I need to make 42 pcs. of for this engine, it is M3 bolts with a 2.6 mm keywidth :
Any comment is welcome
Well I finally got started on my next project.
It will be an engine type looking a bit like the ones used in paddle steamers, the type where the paddle wheel was behind the hull.
A CAD of the hole project :
The project so far :
I also would like to show a close up on the bolts that I need to make 42 pcs. of for this engine, it is M3 bolts with a 2.6 mm keywidth :
Any comment is welcome