Help Support Home Model Engine Machinist Forum:
B
bluejets
Well-Known Member
- Joined
- Last seen
- Messages
- 458
- Reaction score
- 170
Latest activity Postings About
-
-
Bbluejets replied to the thread Temperature of the exhaust of model engine.Well why comment.? Used it for 50 years with no problem...trouble is greenies tend to get involved in many things they don't understand...
-
Bbluejets replied to the thread Temperature of the exhaust of model engine.Blue tip silver solder, cadmium bearing the best if you can track some down.
-
Bbluejets replied to the thread Engine Design basic questions.There is a simple design in here somewhere (plans etc) called "simple simon", a single cylinder engine designed and built by our...
-
Bbluejets replied to the thread Engine Design basic questions.Save yourself some headaches and use a proven design. You'll have you work cut out getting one to run first up as it is. Practice...
-
Bbluejets replied to the thread Wanted Model generator, castings kit..I made my own .....there is enough info on the site above to do the same for yourself.
-
Bbluejets replied to the thread Valve timing.Well if you must hang on small details, yes, but just as difficult to set up.(which, as you can see was successful)...that being the...
-
Bbluejets replied to the thread Valve timing.That's pretty much like chalk and cheese ........Atkinson are difficult to get set up correctly as I have done it successfully.
-
Bbluejets replied to the thread Valve timing.It may be firing well, (whatever that means) but all I see are two induction fully open at the same time, so your "wasted spark is up...
-
Bbluejets replied to the thread Valve timing.Doesn't matter that he has that crank configuration, they're independant in all respects. A few degrees of overlap between exhaust and...
-
Bbluejets replied to the thread Machining Valve Stems.There is a method where one can do it in one cut, allbeit with the correct tool.
-
Bbluejets replied to the thread Struggle with 1/8” dies.Never heard of 1/8" whitworth...???
-
Bbluejets replied to the thread Designspark going subscription?.There is a free version, that was why I posted the web page. There is always Fusion360......🥴
-
Bbluejets replied to the thread Designspark going subscription?.Subscriptions Pricing Page.
-
Bbluejets replied to the thread Valve seat material for B&S lawn mower engine.Centre punch around the edges of the valve seat, in the aluminium, perhaps 1mm from the edge of the seat, with the seat in place. Go all...
-
Bbluejets replied to the thread Help with Arduino idexer.Doesn't always happen....should use the "copy code" in Arduino and then paste in code tags.
-
-
Loading…
-
Loading…