Help Support Home Model Engine Machinist Forum:
Sprocket
- Messages
- 264
- Reaction score
- 267
Latest activity Postings About
-
-
LLoyd The more expensive varifocal lens can have a much wider field of view for reading but will always be worse than pure reading... -
Sprocket replied to the thread What have you been doing today?.You know, they changed the law in 1972 so the Cost Of Living Allowance (COLA) is calculated each year. It doesn't matter who is in office.
-
Sprocket replied to the thread Muncaster Joy Valve Steam Engine 1/2 scale.I'm not sure how it works with acetylene/air, but with oxy/acetylene, you can make the flame slightly carburizing and it helps keep the...
-
Sprocket replied to the thread What have you been doing today?.I work a couple of days a week as a Ski Patrol. This is one of them. New snow last night, clouds haven’t lifted yet. This is the view...
-
-
Sprocket reacted to Foketry's post in the thread 18 Cylinders Isotta Fraschini (straight six-cylinder x3 ) with
Like.
Brass flywheel, This is an aeronautical engine but instead of a propeller on the crankshaft I thought of putting a flywheel to eliminate... -
In the quest to get the sump, crankcase and oil pump fitted together I needed to complete the crank shaft which meant get the oil ways...
-
The spark plugs in the full-size engine are angled down and away from the head to avoid interference with the stock exhaust manifold...
-
Lots done. While the mill was running making a steering wheel I was finishing a few things. I cross drilled the pinion gear and pinned...
-
Sprocket reacted to raveney's post in the thread Muncaster Joy Valve Steam Engine 1/2 scale with Like.
Made the slide valve, valve spindle and some oil cups with covers. Used a shop built ball turner rather then the radius tool for the...
-
Cut more gears today. Internally the transaxle is complete.
-
Sprocket reacted to raveney's post in the thread Muncaster Joy Valve Steam Engine 1/2 scale with Like.
Valve plate material that I had planned on using was a scrap of 304 SS 0.120" plate left over from a heat treat oven build. Not a good...
-
As it turned out, I wasn't able to significantly reduce the number of setups needed to machine the heads. Each one requires 62 drilled...
-
Hi All, Well after a little bit of playing around, "IT'S ALIVE", After about 20mins of runtime now it's swinging a 9x6wide blade with...
-
Here is my version of the ring holder. To overcome the ring removal problem, I make the two parts detachable with a dowel pin to hold...
-
Sprocket reacted to minh-thanh's post in the thread Diesel engine : Kromhout Gardner 4LW 1940 with Like.
Hi All ! An update It seems to be a mistake, maybe I should choose the 2 cylinders But for now there is no choice but to continue
-
-
Loading…
-
Loading…
