I am looking at making a Flame Eater for my next project but I am not sure which one to make. I have several different plans and I was hoping to get some feedback from people who have actually made a flame eater. Since this is my first one, I would like to make one that I am confident with meaning that the plans are good and also that I can get it running with my intermediate knowledge of machining.
The ones I am looking at are attached except for Jerry Howell's 4 in 1 Vacuum Engine which is listed here http://www.jerry-howell.com/4in1.html
I also like Jan Ridder's version shown here...
http://heetgasmodelbouw.ridders.nu/Webpaginas/pagina_happer_inw_schuif/inw_schuif_frameset.htm
After all the videos I have seen on YouTube, I think the like the PM Research "Flame Licker" the best but, I don't know how to get plans for it.
Thank you in advance for your suggestions.
Dan
View attachment FireEater[1].pdf
View attachment FireEater[1].pdf
View attachment Candle_Engine[1].pdf
The ones I am looking at are attached except for Jerry Howell's 4 in 1 Vacuum Engine which is listed here http://www.jerry-howell.com/4in1.html
I also like Jan Ridder's version shown here...
http://heetgasmodelbouw.ridders.nu/Webpaginas/pagina_happer_inw_schuif/inw_schuif_frameset.htm
After all the videos I have seen on YouTube, I think the like the PM Research "Flame Licker" the best but, I don't know how to get plans for it.
Thank you in advance for your suggestions.
Dan
View attachment FireEater[1].pdf
View attachment FireEater[1].pdf
View attachment Candle_Engine[1].pdf