petertha

Hardened dowel type pin should be fine, just check the tolerances. Some are +/- either side of nominal dimension depending on the...

I think that's a good way of doing it. I had similar issue on my radial where the tube mated the rocker box at a 3D inclined angle. I...

Excellent news! Now check your online banking dashboard, maybe you still have the 'conservative mode' switch toggled & deferring some...

I'm not sure if this is relevant or even close to what you are after, but Ken has done some coil work. I emailed him on occasion &...

Fantastic! I would be interested to learn more details of your ignition system (module/coil, distributer, leads, plugs...) & the...

Fuel pressurization in model AC is mostly driven by a need to overcome, or at least stabilize, varying hydrostatic head changes of the...

In the club!

Interesting. Thanks for description. I always assumed 6061 & 356 were quite different compositionally & doing a T4 or T6 treatment to...

It might cost you even more once UPS is done with you if that amount represents the shipping component. Its common (likely) to get a...

Dumb question but have you tried & dismissed a decent quality high build primer in a spray bomb? No gun, no mixing, no compressor, no...

I don't have a Sherline lathe but I use one in a Sherline rotary table which I hold in my 5" mill vise as an expedient way to make...

You can do a check of your spray medium by getting an inexpensive viscosity cup at a (typically automotive) paint store & compare to...

You have it right. Now what some people do is ignore the polarity alignment slot on the Futaba female plug & insert a male JR plug...

Not sure what airbrush you ordered but that sounds problematically thick from my experience. Guess you will find out soon enough. I...

Gordon, more of a side note, but just curious what make of ignition system your are implementing? From some reading I've collected...