Cymro77
Cymro77
Hi,
I am a total novice at machining. This was my first attempt to build anything other than the classic wobbler. My first time to use the rotary table on my mill. I have a Microlux Micro mill and Micro Lathe. The engine runs on about 20psi. My machining tolerances are to blame for the high pressure needed. Hopefully time and experience will improve that.
I am a total novice at machining. This was my first attempt to build anything other than the classic wobbler. My first time to use the rotary table on my mill. I have a Microlux Micro mill and Micro Lathe. The engine runs on about 20psi. My machining tolerances are to blame for the high pressure needed. Hopefully time and experience will improve that.