Hello everyone!
I have a really (being frank here) stupid question: If an end mill holder can hold an end mill securely with just a little divot in the shank and a grub screw, could not in theory on a small machine (Taig) would a small tool holder connect to the spindle the same way- with a grub screw? Basically, flipping the end mill holder upside down and connecting to the spindle.
It's not quite a quick change tool system, but more like a "not so slow change tool system" idea I had.
Thank you in advance for any input/knowledge imparted!
I have a really (being frank here) stupid question: If an end mill holder can hold an end mill securely with just a little divot in the shank and a grub screw, could not in theory on a small machine (Taig) would a small tool holder connect to the spindle the same way- with a grub screw? Basically, flipping the end mill holder upside down and connecting to the spindle.
It's not quite a quick change tool system, but more like a "not so slow change tool system" idea I had.
Thank you in advance for any input/knowledge imparted!