kf2qd

How much does it cost for an table at one of these shows? And what does it cost for a motel room in the city where the show is taking...

I wonder if those weights are spin cast. That might cause some migration of heavier elements to the outside during the pour. Probably a...

That is a really cool design. I like it.

Already printed one out and taking it to work Monday...

And just hope the castings don't have much nickel... I worked in a foundry for a while where we had 2 furnaces. An induction furnace...

Part of the problem is that thing called a funeral. Those in the hobby are growing older and there are not many coming along to replace...

Not everything scales, and if you have any compenstation for holes in the unscaled part, that might well change when you scale. The...

Sounds like you need to pull the spindle and check all the clearances behind the bearing next to the chuck. If it is tightening up under...

You don't take it apart. You need a proper fixture to preload the bearing and mount it by the morse taper and then regrind it. Send it...

Are you sure the are oilite and not just bronze bushings?I would suspect that they are plain bronze bushings.

Sorry, I make chips that are bigger than that...

From the pictures the motor castings look identical. The O&S has a different base plate with the name cat in and the I&P has a brass...

It would be interesting to get an Isbel-Porter and an O&S next to each other and see if one was different in size by the shrink factor...

There is a lot of motion in that design. Would be very hard on inserts and thread quality. At the start of the thread the tool moves...

I would think that the function of the governor would also be heavily affected by the mass of the engine and it's load. A lighter engine...