Needed a 9/32 (.281) tubing bender. Of course you cant find one sooooo, I made this quick and dirty bender. A piece of 1/4 X 1 is used. A 90 degree bend is made on the end and the milling begins. The swivel handel is also 1/4 X 1 milled down to 5/8 wide. There were 4 holes drilled and 3 were tapped. The 2 rollers were made and there ya have it. The entire thing took about an hour and a half start to finish.
I have seen some very nice benders but I could not find plans for any of them so you do what you have to. When the Bismuth gets here I'll let you know if it works or destroys itself.
I have seen some very nice benders but I could not find plans for any of them so you do what you have to. When the Bismuth gets here I'll let you know if it works or destroys itself.