dwentz
Well-Known Member
- Joined
- Dec 20, 2007
- Messages
- 120
- Reaction score
- 5
OK I am working on a project and need to cut a 90 Degree V in a part .133 Deep.
I have the part to be machine set at a 45 Degree angle and have the corner of the mill set at the center line of the cut.
What I can not figure out is how deep and how for back do I need to move the part to get the correct depth of .133
I have done this before by trial and error, but it would be nice to get this one correct.
I have the part to be machine set at a 45 Degree angle and have the corner of the mill set at the center line of the cut.
What I can not figure out is how deep and how for back do I need to move the part to get the correct depth of .133
I have done this before by trial and error, but it would be nice to get this one correct.