Rozlo
Active Member
- Joined
- Oct 19, 2015
- Messages
- 33
- Reaction score
- 0
I looked at this lathe last weekend and I can pick it up for less than $500 with all of the tooling which is several boxes. My question is that the thread plates and transmission plates are worn pretty good and you cannot see all of the speed selections not sure if I want to take the time to pull it apart and take it out of the guys basement. Also cannot find a ID plate anywhere on it but I think it is a 13" x 30ish not sure on the length. What are your guys thoughts. It turns good I think it may need some adjustment in the clutches but not sure, also needs a good cleaning.
Thanks
Bill
Thanks
Bill