I needed a long series drill (below - for obvious reasons) - simply drilled a piece of rod and used Locktite stud lock to secure.
The shank end is a little smaller than the drill and allows the adhesive to wick in and was ready to use in a few minutes.
A quick heat with a butane torch to recover my original drill and the rod.
FYI
Regards, Ken
The shank end is a little smaller than the drill and allows the adhesive to wick in and was ready to use in a few minutes.
A quick heat with a butane torch to recover my original drill and the rod.
FYI
Regards, Ken
Last edited: