Jim May’s “May Engine”

[fltenwheeler]

Hi All

I recently purchased a set of castings for a Jim May’s “May Engine”. I have most of the drawings, total of 18, but am missing some. I need to find the Crankshaft, Flywheel, Crankshaft bearings, and the Camshaft Gearing drawings.

Thanks for any help.

Tim Meyer

 

[kuhncw]

Hi Tim,

Based on this Smokstak post, Bob Bishop owns the patterns and drawings for the engines Jim May developed.

Scroll down a bit in the thread and there is an address. I hope it is still good.

Regards,

Chuck

http://www.smokstak.com/forum/showthread.php?t=71198

 

[fltenwheeler]

Thanks, I will give him a call.

Tim