Help Support Home Model Engine Machinist Forum:
fltenwheeler
Well-Known Member
- Joined
- Last seen
- Messages
- 296
- Reaction score
- 66
Latest activity Postings About
-
-
fltenwheeler reacted to Richard Carlstedt's post in the thread USS Monitor Steam Engine Drawings with
Like.
All There have been many postings on various Forums about this engine and requests for drawings You may know that only a few drawings of... -
fltenwheeler replied to the thread Casting brass..Get so bronze screws and drill and tap the gear. Then braze the area and recut the gear. Tim
-
fltenwheeler replied to the thread Selection of Steel to use.This is from the McMaster Catalog. What they call Low Carbon Steel is most likely 1018. Tim
-
-
fltenwheeler replied to the thread Selection of Steel to use.I use 1144 stress proof steel for most of my parts. It machines great. For my high stress parts I use 4140HT. I build 1/8 scale steam...
-
Hello all you there, I want to mill UNF 5/16 20 and #10 32 on my cnc mill with a 60° thread mill. I live in Germany and am not familiar...
-
A twin based loosely on the Westbury Wallaby nearing completion.
-
Hi Ghosty, I agree if you want a press fit, but anaerobic adhesives usually specify a clearance, usually very small. (I think? - The...
-
In 1975, I bought my first calculator. It was a TI and cost 156.09$ (that was with tax). Today that same calculator sells for about...
-
fltenwheeler replied to the thread Press Fits.Sorry I missed it. This is what they want. LOCTITE® 680, it is 0.05 mm to 0.38 mm. 0.0019” to 0.0149” Looks like the minimum is 2...
-
fltenwheeler replied to the thread Press Fits.What grade of Loctite did you use? I have an oddball one that I use at steam meets when someone’s wheel comes loose. It has it own...
-
fltenwheeler replied to the thread Briesch Steam Hammer.I found the drawings. I will take them and have them scanned. Tim BYW If anyone is interested I would like to sell my steam hammer...
-
fltenwheeler replied to the thread Press Fits.Hi Harvey The H7 hole size takes into account the tolerance that a reamer can produce. From 0.6250" to 0.6257" diameter. For most...
-
fltenwheeler replied to the thread Press Fits.Hi Craig If you would click on the link it will explain a lot. I can measure to the 0.0001” of a 5/8” hole with a snap gauge. My...
-
fltenwheeler replied to the thread Press Fits.I redid the file with more realistic sizing. Here is a treasure trove of information. Tim
-
-
fltenwheeler replied to the thread Briesch Steam Hammer.I has the hammer and plans I will see what mine look like. Tim
-
-
Loading…
-
Loading…
