Any clues as to what will stick to this stuff...?
By the feel of it I don't think much will stick to it....
Oh, I need to glue a small plastic switch into a slot, it quite a good fit as it is but a dab of glue would help hold it in place.
Dave
Glue for Delrin..?
- Thread starter DaveRC
- Start date
Help Support Home Model Engine Machinist Forum:
Any clues as to what will stick to this stuff...?
By the feel of it I don't think much will stick to it....
Oh, I need to glue a small plastic switch into a slot, it quite a good fit as it is but a dab of glue would help hold it in place.
Dave
Majorstrain
Well-Known Member
- Joined
- Dec 24, 2008
- Messages
- 304
- Reaction score
- 4
Hit it with a dab of hot glue on the back of the panel from the hot glue gun.
That might do the trick.
Cheers
Phil
That might do the trick.
Cheers
Phil
- Joined
- Jan 19, 2010
- Messages
- 1,193
- Reaction score
- 41
I asked this same question awhile back.
Lots of good info here. http://www.homemodelenginemachinist.com/index.php?topic=11186.0
I have not yet tried theses methods, but I have joined two pieces of delrin by getting them hot and then sticking them together. It was a bit tricky, but I was able to machine across the joint without seperation.
Kel
Lots of good info here. http://www.homemodelenginemachinist.com/index.php?topic=11186.0
I have not yet tried theses methods, but I have joined two pieces of delrin by getting them hot and then sticking them together. It was a bit tricky, but I was able to machine across the joint without seperation.
Kel
