spazman_77
Member
- Joined
- Mar 23, 2008
- Messages
- 14
- Reaction score
- 0
well after being on lay off from the tool room all summer i have finally produced a nice set of castings, based on a model engine some one gave me, but now that im ready to machine i have a few questions.
A) what mtrls are used for base gasket? and head gasket?
B) the wrist pin and the crank jurnal are gonna be 1/4 drill rod, if i ream my bearings to .251 is that to loose of a fit?
this is a 2 stroke , mag fired engine, its my first engine build, but i figure, after 15 years in the tool room making parts for stamping presses, this cant be to hard to machine up
and yes the casting were made in the back yard
thanks in advance
A) what mtrls are used for base gasket? and head gasket?
B) the wrist pin and the crank jurnal are gonna be 1/4 drill rod, if i ream my bearings to .251 is that to loose of a fit?
this is a 2 stroke , mag fired engine, its my first engine build, but i figure, after 15 years in the tool room making parts for stamping presses, this cant be to hard to machine up
and yes the casting were made in the back yard
thanks in advance