Finished - Elmer's #12 - 1.5x

[vederstein]

After a bit of adjusting, I'm calling my Elmer's #12 complete. It didn't pump too good until I added some clearance between the rotor and the pump cover. Now I'm satisfied with the pumping performance.

Video below...

[ame]http://youtu.be/pLwApvULAL0[/ame]

 

[mirek111]

It is hum!

 

[Sshire]

That must be the least- built of Elmer's engines. I don't believe I've ever seen it.
Nicely done.

 

[vederstein]

Steaming day on Easter.

This is the same engine, but on live steam of about 55 psi. You can't tell from the video, but the water stream went up about five feet.

http://youtu.be/xP1j9oAMZlw

...Ved.

 

[vascon2196]

I love it...great job!

Yet another one on my never ending bucket list.