- Joined
- Jun 4, 2008
- Messages
- 3,285
- Reaction score
- 630
I've been shopping eBay for a face mill with a R8 shank for a while, and finally found one I like. 3" diameter Mitsubishi that uses square inserts (SEEN type).
Tried it out on some HRS and then this chunk of 6061 on the bridgeport. This will save a lot of time preparing stock over 3/4" end mills.
It came with 40 additional new inserts of several different types; I need to research what materials each of the different inserts is best for.
Tried it out on some HRS and then this chunk of 6061 on the bridgeport. This will save a lot of time preparing stock over 3/4" end mills.
It came with 40 additional new inserts of several different types; I need to research what materials each of the different inserts is best for.
