Hi Folks
I have just acquired a jacobs chuck in very good condition, but minus
the arbor.
The writting on the side of it reads 34-02 0-1/2in 0-13mm 2 taper
and my question is this, how do i determine whether it is a
MT2 - JT1 MT2 - JT2 ect.
For use on my lathe which has a MT2 tailstock.
Ideally i would like to use it on my mill, but my mill is a MT3 and uses
a 12mm draw bar. not sure if such an adapter exists scratch.gif
Any Help you very experienced folks could give would be very much
appreciated
Ken
I have just acquired a jacobs chuck in very good condition, but minus
the arbor.
The writting on the side of it reads 34-02 0-1/2in 0-13mm 2 taper
and my question is this, how do i determine whether it is a
MT2 - JT1 MT2 - JT2 ect.
For use on my lathe which has a MT2 tailstock.
Ideally i would like to use it on my mill, but my mill is a MT3 and uses
a 12mm draw bar. not sure if such an adapter exists scratch.gif
Any Help you very experienced folks could give would be very much
appreciated
Ken