K
Kludge
Guest
About a year ago, I "inherited" a Dremel table saw in not all that good condition. The blade useless, rust is fairly all-covering and a few pieces are missing. On the other hand, the motor works and it really isn't a bad piece for woodwork. There are even some really nice slitting blades that fit it.
To remove or change the blade requires a really long skinny wrench that I didn't get with mine. I would dearly love to have one of these wrenches so I can remove the existing slightly dangerous flywheel so I can finish dismantling the saw and put it on its way to recovery. I would make one but, as you all have seen, my shop's not geared to anything largish and even that wrench is outside it's capabilities.
Any help would be greatly appreciated.
BEst regards,
Kludge
To remove or change the blade requires a really long skinny wrench that I didn't get with mine. I would dearly love to have one of these wrenches so I can remove the existing slightly dangerous flywheel so I can finish dismantling the saw and put it on its way to recovery. I would make one but, as you all have seen, my shop's not geared to anything largish and even that wrench is outside it's capabilities.
Any help would be greatly appreciated.
BEst regards,
Kludge