B
Bogstandard
Guest
This is a job that I did this morning, it really pushed my little old mill/drill to the limits. I had to machine some 20mm slots in the rear of the frame to make the rear wheel adjustable. The chap was changing this rigid chopper frame from one with a shaft drive engine to a billet engine with chain drive.
Just managed to get the cutter in, and it took 1 1/2hours to set up and machine each slot. There wasn't a single point on the rear end we could use for a datum, so we had to make our own before we could cut the slots
And here is Bogstandard eyeing up whether he can make a steam engine to fit the frame.
John
Just managed to get the cutter in, and it took 1 1/2hours to set up and machine each slot. There wasn't a single point on the rear end we could use for a datum, so we had to make our own before we could cut the slots
And here is Bogstandard eyeing up whether he can make a steam engine to fit the frame.
John