Scotty's Boll Aero Glow

Home Model Engine Machinist Forum

Help Support Home Model Engine Machinist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

scottyp

Well-Known Member
HMEM Supporting Member
Joined
Nov 16, 2017
Messages
166
Reaction score
116
Location
North Dakota
Here is my rendition of the Boll Aero Glow .49 cu in. It is a simple and nice engine to build, not too big or too small. I enjoyed the build and finally got the motivation to finish it up and get it running so I could cross it off of my build list.
 

Attachments

  • IMG_5169.JPG
    IMG_5169.JPG
    1.9 MB · Views: 19
  • IMG_5170.JPG
    IMG_5170.JPG
    1.7 MB · Views: 0
  • IMG_5171.JPG
    IMG_5171.JPG
    1.8 MB · Views: 0
  • IMG_5172.JPG
    IMG_5172.JPG
    1.8 MB · Views: 0
  • IMG_5173.JPG
    IMG_5173.JPG
    2.1 MB · Views: 0
Last edited:
...And it runs! Pretty well anyway. I think it could use a little more carb and/or a little less prop, but I am rather satisfied at this point. (Sorry I-phone users, you may not hear the awesomeness. I had to downsize the video to an mp4.)
 

Attachments

  • IMG_E5184 yt.mp4
    6.6 MB
Last edited:
Here is my rendition of the Boll Aero Glow .49 cu in. It is a simple and nice engine to build, not too big or too small. I enjoyed the build and finally got the motivation to finish it up, get it running so I could cross it off of my build list.
Looking good, can't wait to see the video of it ruining.
 
...And it runs! Pretty well anyway. I think it could use a little more carb and/or a little less prop, but I am rather satisfied at this point. (Sorry I-phone users, you may not hear the awesomeness. I had to downsize the video to an mp4.)
Nice engine, runs great, Congratulations !
👍 .
 
I mis-read this thread, and had 0.049 fixted in my head.

I watched the video, and did a double-take; that is a big boy, not an .049.
And runs so very well !

I am getting old I think.
.
 
Last edited:
Back
Top