Polished & Pictured Again!

[esteam]

Hello!

My Jan Ridders Flame Licker is polished a little bit by me

And my amateur photographer nephew took her photos.

Here she is:

Regards

Erdem

 

[brian99s]

Very nice looking engine! Good photography also. I just received the drawings from Jan this weekend and want to begin this build. I assume you used stainless on the cylinder. I was going to use cast iron but after looking at your finished work I will change my direction.

Once again very beautiful.

Brian

 

[Bernd]

Nice looking engine esteam. Now your nephew needs to do a video of her running.

Bernd

 

[Maryak]

Erdem,

Beautiful finish. :bow:

Best Regards
Bob

 

[NickG]

Very nice, don't give up on getting it to run though!

 

[esteam]

Thank you guys. I will try to run this engine next week again.

Brian, I didn't use stainless steel on the cylinder. It's just cheap steel. May be you call "cast iron". But in my country they call it "transmission steel". I think it's same as cast iron

Regards

Erdem