Polished & Pictured Again!

Home Model Engine Machinist Forum

Help Support Home Model Engine Machinist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

esteam

Well-Known Member
Joined
May 7, 2008
Messages
86
Reaction score
0
Hello!

My Jan Ridders Flame Licker is polished a little bit by me :)

And my amateur photographer nephew took her photos.

Here she is:

EOS_6595.jpg


EOS_6601.jpg


EOS_6613.jpg


Regards

Erdem


 
Very nice looking engine! Good photography also. I just received the drawings from Jan this weekend and want to begin this build. I assume you used stainless on the cylinder. I was going to use cast iron but after looking at your finished work I will change my direction.

Once again very beautiful.

Brian
 
Erdem,

Beautiful finish. :bow:

Best Regards
Bob
 
Very nice, don't give up on getting it to run though!
 
Thank you guys. I will try to run this engine next week again.

Brian, I didn't use stainless steel on the cylinder. It's just cheap steel. May be you call "cast iron". But in my country they call it "transmission steel". I think it's same as cast iron :)

Regards

Erdem
 
Back
Top