Need help with mill reverse wiring

Home Model Engine Machinist Forum

Help Support Home Model Engine Machinist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

cessna

Well-Known Member
Joined
Feb 28, 2010
Messages
183
Reaction score
4
Hi, I have been searching the web about a fwd rev switch for my mill. It is a G1005Z, I have a reversing drum switch and a diagram for it, it is a Kedu ZH-HC-3.
Every diagram I find shows a different junction box including the one in the manual. The one on my machine has three jumpers that I don't see on any of the others. I will try and include a pic.
Thanks for any help you offer.
Terry

junction box06292014_0000.jpg
 
Might be helpful if you included a photo of the diagram on the inside of the cover.
 
Thanks for your reply, the diagram on the inside only shows hookup for 110 or 220 volt, however I was able to figure it out using a toggle switch to change motor lead 5 and 6.
Terry
 

Latest posts

Back
Top