- Joined
- Jan 19, 2010
- Messages
- 1,193
- Reaction score
- 41
I know this aint no engine, but I thought I would share a project I decided to take on shortly after I got my mill.
So, I was at the steel yard getting some barstock, and I seen a wonderful peice of steel sitting on the rack. It was 2 1/2" x 3" rectangle bar of mild steel. I had wanted a small vice to put on my angle table for some time. But I never got around to ordering one. When I seen this bar of steel, I said to myself, "There is my new vice!" So I had them cut a foot of it off for me. Found out in the office it was $40 foir that foot. But thats OK, Ime gonna get soem good milling experience.
So, I was at the steel yard getting some barstock, and I seen a wonderful peice of steel sitting on the rack. It was 2 1/2" x 3" rectangle bar of mild steel. I had wanted a small vice to put on my angle table for some time. But I never got around to ordering one. When I seen this bar of steel, I said to myself, "There is my new vice!" So I had them cut a foot of it off for me. Found out in the office it was $40 foir that foot. But thats OK, Ime gonna get soem good milling experience.