I have the training manuals for both mill and lathe aswell as the user notes.
starting off with the Mill.
I am stuck on page 1-6 of tutorial 1.
which is 3.3 " creat the arcs knowing the center point and the radius/diameter"
the book is asking me to select the fast point icon and enter the coordinates: 0.56+3.5,-1.5
this will automatically put in a circle in the part (at those coordinates).
but when I do this nothing happens, its frustrating :big:
its hard to explain, but hopefully someone has the book themselves and can look it over.
regards
starting off with the Mill.
I am stuck on page 1-6 of tutorial 1.
which is 3.3 " creat the arcs knowing the center point and the radius/diameter"
the book is asking me to select the fast point icon and enter the coordinates: 0.56+3.5,-1.5
this will automatically put in a circle in the part (at those coordinates).
but when I do this nothing happens, its frustrating :big:
its hard to explain, but hopefully someone has the book themselves and can look it over.
regards