Make offer....

[lotsasteam]

jUST can't get used to the inches measurement ,all my machining is done in metric ,so i'll part with those ,make offer for each item!

Manfred http://www.homemodelenginemachinist.com/f13/found-some-goddies-20072/

 

[Sshire]

$50.00 + shipping?

 

[excelfreak]

$60 + shipping

 

[aarggh]

Ok, I would really like these so $75 + shipping, that's US dollars not Aussie ones, as our exchanges rates pretty bad atm.

cheers, Ian

 

[excelfreak]

$80 + shipping
I would really like those too, especially since i don't have any yet - I am just gathering my tooling and have a little Sherline mill and lathe

 

[Tin Falcon]

Excelfreak could you would you please post an introduction in the welcome area.

Tell us a bit about yourself your shop and your interest in model engine building.

Tin

 

[excelfreak]

Tin,

sure - where is the welcome area?

Please advice

 

[Tin Falcon]

second sub for from the top of the home page should not be hard at all to find.
Tin