Is it possible to machine neodymium (rare earth) magnets? If so, could you please give me some tips on how it is done.
I haven't attempted it yet, but I have a project in mind that would need a curve put on the flat ends of a magnet. Think drilling a cross hole in a bar of brass, putting the magnet in and machining the end of the magnet to conform to the diameter of the bar.
Dave
The Emerald Isle
I haven't attempted it yet, but I have a project in mind that would need a curve put on the flat ends of a magnet. Think drilling a cross hole in a bar of brass, putting the magnet in and machining the end of the magnet to conform to the diameter of the bar.
Dave
The Emerald Isle