tel
Well-Known Member
- Joined
- Feb 8, 2008
- Messages
- 3,293
- Reaction score
- 44
The modest start to yet another popcorn engine.
1. Flywheel - straight spokes because the 1/4" brass rod I had refused to bend even after heavy annealing, it would go so far then snap (cold short).
2. Cylinder - slightly modified from Stew's design. Bore take out to 9/16" amd a little longer.
3. The other end - 5 bolts in this end - just to be different.
More to come as it progresses, but it won't be an intense build thread - that's been pretty well covered already.
1. Flywheel - straight spokes because the 1/4" brass rod I had refused to bend even after heavy annealing, it would go so far then snap (cold short).
2. Cylinder - slightly modified from Stew's design. Bore take out to 9/16" amd a little longer.
3. The other end - 5 bolts in this end - just to be different.
More to come as it progresses, but it won't be an intense build thread - that's been pretty well covered already.