- Joined
- Dec 28, 2008
- Messages
- 1,731
- Reaction score
- 9
I occasionally use 90 degree 3/16 cast bronze elbows on my builds. I buy the inexpensive trees available from PM Research
I like the way they look and they are a good alternative to bent tubing that needs to be epoxied or soldered in place.
I end up marring them with my vise. Getting both ends drilled and tapped on center and at a true 90 degrees, has been a hit- miss proposition.
Does anyone have any ideas, or a good set up that gets accurate results?
-MB
I like the way they look and they are a good alternative to bent tubing that needs to be epoxied or soldered in place.
I end up marring them with my vise. Getting both ends drilled and tapped on center and at a true 90 degrees, has been a hit- miss proposition.
Does anyone have any ideas, or a good set up that gets accurate results?
-MB