Home Model Engine Machinist Forum

Help Support Home Model Engine Machinist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Mike N
Reaction score
303

Latest activity Postings About

    • Mike N
      I'm not home right now to test this sketch until next week sometime. As I look through the code I don't see where the missing steps are...
    • Mike N
      Does that version make up the missing steps, due to dropping the digits after the decmil? Where could I find a copy of his sketch?
    • Mike N
      Mike N replied to the thread Help with Arduino idexer.
      The sketch in post #54 works perfect for cutting gears if you use the "B" option (number of Divisions). It repeats back to the starting...
    • Mike N
      This looks really nice, are you using the sketch that Timo modified to pick up the missing steps to make sure you end up where you...
    • Mike N
      Mike N replied to the thread Help with Arduino idexer.
      Update: The sketch that Timo posted here #54 completely solved the missing steps problem. The rotation always comes back to "zero"...
    • Mike N
      Mike N replied to the thread Help with Arduino idexer.
      Thanks for explaining this. 🙂
    • Mike N
      Mike N replied to the thread Help with Arduino idexer.
      https://forum.arduino.cc/t/stepper-motor-division-of-one-rotation-mostly-math/1065635?page=2 There were 32 posts in this thread, my...
    • Mike N
      Mike N replied to the thread Help with Arduino idexer.
      For angle inputs are we limited to 2 place decibels or could we have 3 or 4 place? I noticed that the accumulated moves on the display...
    • Mike N
      Mike N replied to the thread Help with Arduino idexer.
      I setup my test station again & tried this sketch. I set the parameters to match my 800 steps on the driver & 40 to one ratio on my...
    • Mike N
      Mike N reacted to Schatten's post in the thread Help with Arduino idexer with Like Like.
      Hallo Mike N, I tried this, My turntable is 1:36. An intermediate drive It has a gear ratio of 1:60. If you can, try it. Code: /*...
    • Mike N
      Mike N replied to the thread Help with Arduino idexer.
      Yes, you can enter angles with 2 digits after the decimal. If you ask for 45 degrees you get it, if you want 44.4444 it gives 44.44 The...
    • Mike N
      Mike N replied to the thread Help with Arduino idexer.
      That's exactly what Timo accomplished on Monday with his revised sketch, find it earlier in this thread.
    • Mike N
      Mike N replied to the thread Help with Arduino idexer.
      Timo, Thanks for explaining this so every one can understand whats going on here. I just looked at the spreadsheet I worked on Sunday: A...
    • Mike N
      Mike N replied to the thread Help with Arduino idexer.
      I know there have been several years of discussion about building a digital dividing head using a Arduino on HMEM. I think I read every...
    • Mike N
      Mike N replied to the thread Help with Arduino idexer.
      Thanks for looking at this. It is working good now. Timo made some changes to the sketch & now the missing steps have been added into...
  • Loading…
  • Loading…
Back
Top